winch assembly
treuil
davit assembly
bossoir
NOTE: Numbers in ( ) are item numbers referring to parts diagram.
A. Winch and Davit mounted together
1.
Remove DeckHand cover (1) by removing cover screws, items (3) and (4).
2. Place the base (18) and the davit (53) in your desired mounting location. Make sure that when
the DeckHand is operating or in a stowed position, the anchor does not come in contact with the
boat.
3. Make sure there are no obstructions under the mounting surface prior to drilling. Mark at
least 4 of the 6 pre-drilled bolt hole location provided in your base for drilling. Also mark all 4 pre-
drilled bolt hole locations provided in your davit for drilling. Drill through the marked holes in the
base using a
21
/64”
drill bit, and through the marked holes in the davit using
17
/64”
drill bit.
3”
75 mm
cover
base
bolt
rubber washer
flat washer
rondelle
plate
nut
INSTRUCTIONS
OWNER’S MANUAL
Model:
DH 25R
DeckHand
™
To Next Page
General