MKA-4 BOWMOUNT STABILIZER KIT
1862013
Item /
Assembly
Part # Description Qty.
A
Items 2-10
2994841 BAG ASSY, STABILIZER STRAP 1
2 2263464 SCREW-1/4-10 X 1 HH TYPE A SS 1
4 2011720 LOCKWASHER-PROP (SMALL) 2
6 2268400 SHAFT-SUPPORT, MAXXUM 1
8 2268401 BUMPER-SHAFT, MAXXUM 1
10 2773804 STRAP-HOLD DWN,30.5,w/HANG TAG 1
p
2264990 INSTRUCTIONS STABILIZER/STRAP 1
p Not shown on Parts Diagram.
MOUNTING CONSIDERATIONS
TOOLS AND RESOURCES REQUIRED
• Hand Saw • 3/8” Nut Driver • File or Sandpaper
The MKA-4 is recommended for use with Maxxum, Maxxum Pro, Riptide SM and Riptide Pro Minn Kota
®
motors.
The Bow-mount Stabilizer Bracket is used to stabilize the Maxxum Mount and reduce bouncing when the motor is stowed and transported.
Attention to detail is needed for successful installation of the stabilizer. When the motor is stowed, the adjustable stabilizer is positioned
vertically between the Upper Arm of the bracket and the deck of the boat. We recommend having the stabilizer kit installed by a qualified
marine installer.
22
44
1010
66
AA
88
a. Before mounting the trolling motor, place the Hold
Down Strap (Item #10) under the Bow-mount
between the Mounting Holes near the back of the
motor rest, with the hook and loop side of the strap
facing down.
b. Secure the Bow-mount with the Mounting Bolts
included with the trolling motor to capture the Hold
Down Strap as noted in the “Installation of the
Bow-mount” section of the Owner’s Manual.
Hold Down Hold Down
StrapStrap
Bow-MountBow-Mount
Mounting Mounting
HolesHoles
Installation of the Hold Down Strap
BowBow
1
1a
INSTALLATION
ITEM(S) NEEDED
#10 x 1
1 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
To Next Page
Need help?
General
