1 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
C
12
8
6
D
18 16 14
• Wire Stripper
• Pencil or marking tool
• Wire Cutter
• Ruler
• 3/32" Allen Wrench
• Heat Gun
• Marking Tool
• Drill
• 1-¾" Hole Saw
• 1/8" Drill Bit
• Phillips Screw Driver
Before installing your Trolling Motor Plug and Receptacle, please
give consideration to the following:
1. The mounting surface needs to have a flat surface no less
than 3-¼” wide x 2-½ inches high. Use the Face Plate (Item
#2) to check for clearance at the desired mounting location.
Item /
Assembly
Part # Description Qty.
A 2996707 PLUG ASSEMBLY 1
B 2996708 RECEPTACLE 1
C 2990214 COVER-DUST ASSEMBLY 1
F
Includes A & D
2776707 PLUG ASM, TROLLING MTR PLUG KIT 1
H
Includes B & D
2776708 RECEPTACLE ASM, TRL MTR PLUG 1
2 2376458 PLATE-FACE 1
4 2375425 COVER-SPLICE 1
D
Includes 6-18
2994938 BAG ASM, TROLLING MTR PLUG 1
6 2095400 SHRINK TUBE,16MM, 2", 4:1 4
8
✖
SCREW-#8-18X1-1/4 PPHSMS SS 4
10 2014800 ▲ BAG-ZPLCK (4X6) 4ML Clear 1
12
✖
SPLICER, 6-10 AWG, TIN PLTD 4
14 2372950 FERRULE,6 AWG,.47" TIN PLTD 2
16 2372951 FERRULE,8 AWG,.47" TIN PLTD 8
18 2372952 FERRULE,10 AWG,.47"TIN PLTD 2
20 2377117 ▲ INSTRUCTIONS, TRLL MTR PLUG 1
22 2374651 O-RING (INCLUDED IN ASSEMBLY B) 1
TOOLS AND RESOURCES REQUIRED
MOUNTING CONSIDERATIONS
MKR-26
TROLLING MOTOR PLUG AND RECEPTACLE
1865128
✖ This part is included in an assembly and cannot be ordered individually.
▲ Not shown on Parts Diagram.
WARNING
Do not tin any wires with this installation. Tinned wires could
cause the connection to loosen over time, creating an improper
connection. Improper connections could cause a short or
extreme fire danger. Follow the installation instructions provided
to avoid product failure and injury.
WARNING
Make sure the power source is disconnected or, if controlled by
a switch, turned OFF before beginning installation of the Plug
Receptacle. Failure to remove power from the Boat Wires could
cause electric shock.
NOTICE: If uncomfortable making this installation,
we recommend to have the Motor Plug and Receptacle
installed by a qualified marine installer.
A
F
H
4
2
22
B
To Next Page
Need help?
General
