2726
Use the built-in flash's red-eye reduction mode to
reduce the red-eye effect when photographing people
or animals in low-light situations. The flash will fire a
few short bursts before the main flash burst to reduce
the red-eye effect.
Pre-flash Main Flash
AUTOFLASH WITH RED-EYE REDUCTION
When you turn the camera on, the built in flash is automatically set to autoflash
or autoflash with red-eye reduction, whichever was used last. In these modes,
the flash will fire automatically in low-light and back-lit situations.
FLASH RANGE
The range of the built-in flash depends on
the film speed and focal length you are
using. To ensure proper exposure, make
sure your subject is positioned within the
flash range.
37.5mm
125mm
0.6 - 4.6m
2.0 - 15.2 ft.
0.6 - 9.2m
2.0 - 30.4 ft.
0.6 - 4.8m
2.0 - 15.8 ft.
0.6 - 2.4m
2.0 - 7.9 ft.
ISO 100
ISO 400
USING THE BUILT-IN FLASH
Press the flash-mode button until appears
in the data panel, then take the picture.
• Warn your subject the flash will fire a few short bursts
just before the picture is taken.
To Next Page
Loading...
