EasyManuals Logo

Minolta Auto Meter IV F User Manual

Minolta Auto Meter IV F
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
iuiiffi*tuffirffilf
iii+irffi{#ffitru''iitffiffiffiilitiffitiitiiffii!$iifii+irfi.*liirH*ril$rii
lf the
reading is
over or under
the meter's
display
range,
FNo.
and
o
(over)
or u
(under)
will
blink.
lf the
reading is
over or under the
meter's measuring range,
o or u
will
blink and
E will
appear
in the
digital display.
lf
you
change the shutter speed after
you
make
a
measure-
ment, the aperture display,
analog
display, and
any data
in
memory
will
clear.
The trigger
voltage
of some electronic
flash
units
may
be
too
high
for
the
Auto Meter lV F
to
fire
them
in
cord mode. lf this
is
true of
your
flash,
use
non-cord mode
(see p.
25).
Without a
Sync
Cord
1 . Press
the
power
button
to
turn the
meter on.
.
The
most
recent settings
will, appear
in the
display
window.
2.
Refer
to
p.11
and
set
the desired
film
speed.
3.
lf the
meter
is
not set
to
non-cord
mode,
press
the
mode button
until
NON.C
appears
in the display
win-
dow.
o
Any data
in
the aperture
display
or
in memory
will
be
cleared
at
this
point
and
the
to
1/500
-
1
sec.
shutter-speed
range
will change
.
EV display
cannot
be
selected
in non-cord
mode.
24
25
www.orphancameras.com

Other manuals for Minolta Auto Meter IV F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minolta Auto Meter IV F and is the answer not in the manual?

Minolta Auto Meter IV F Specifications

General IconGeneral
BrandMinolta
ModelAuto Meter IV F
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals