Need help?Do you have a question about the Minolta Flash meter IV and is the answer not in the manual?
General| Light Receptor | Silicon photo cell |
|---|---|
| ISO Range | ISO 3 to 8000 |
| Shutter Speed Range | 30 min to 1/8000 sec |
| Display | LCD |
| Type | Handheld Flash Meter |
| Measuring Modes | Ambient, Flash |
| Measuring Range (Ambient) | EV -2 to EV 19.9 (ISO 100) |
| Measuring Range (Flash) | f/1.0 to f/90.9 |
How to insert and replace the AA-size battery for the meter's operation.
Steps to set the ISO film speed using the up/down control and function switch.
Instructions on how to attach and remove the spherical diffuser and reflected-light attachment.
How incident-light readings are based on light falling on the subject, not reflectivity.
How reflected-light readings average light from the scene to provide correct exposure for medium-gray tone.
Steps to perform ambient light measurements using shutter-priority.
Steps to perform ambient light measurements using aperture-priority.
Steps to measure flash using CORD mode in TIME priority.
Steps to measure flash using CORD mode in FNo. priority.
Steps to measure flash using NON.C mode in TIME priority.
Steps to measure flash using NON.C mode in FNo. priority.
How to retrieve stored measurements from memory using the On/Recall button.
Method for measuring light tones to retain highlight detail, especially for slide film.
Method for measuring dark tones to ensure shadow areas receive sufficient exposure.
Method to average highlight and shadow measurements for overall best exposure.
How to increase or decrease exposure by holding a key and using the up/down control.
How the analyze function indicates flash and ambient light contributions to exposure.
How to determine Exposure Value (EV) for ambient light measurements.
Triggers a flash unit via remote control using infrared signals.
Enables wireless remote control of Minolta cameras and data transfer from the meter.
To Next Page
