Do you have a question about the Minolta AUTO METER IIIF - PART 1 and is the answer not in the manual?
Brand | Minolta |
---|---|
Model | AUTO METER IIIF - PART 1 |
Category | Measuring Instruments |
Language | English |
How to insert the correct battery type into the meter.
Explains the meter's power usage and automatic shut-off feature.
Describes how to attach a protective guard for the keys.
Details how to set the film speed (ASA/ISO) for measurements.
Explains the analog scale and its use with digital readings.
How the meter indicates readings outside its measurement range.
How to use the lock switch to prevent accidental measurements.
How to store and recall up to two ambient or flash light readings.
How to calculate an average exposure value from two stored readings.
Step-by-step guide for measuring ambient light.
How to set the shutter speed for ambient light measurements.
How to switch between f-number and EV display modes.
Instructions for taking incident light readings with the diffuser.
Step-by-step guide for measuring electronic flash.
Attaches for reflected-light measurements with a 10° acceptance angle.
Provides a 40° acceptance angle for reflected-light readings.
Used for flat subjects, illuminance, and brightness ratio measurements.
Remote receptor for incident light in inaccessible positions.
Sensor for bright scenes or SLR eyepiece measurements.
Used in the darkroom for calculating enlarging exposure.
Extends measurement range for very bright light conditions.
Instructions on how to attach and detach various accessories.
How to perform reflected-light measurements using specific accessories.
Procedure to determine illuminance ratios between light sources.
How to use the Spot Mask for enlarging exposure measurements.
How to measure illuminance in lux using the flat diffuser.