6. Loading the Film
(Fig. 13)
Use 35 mm (size 135) film in this camera. The
camera will automatically set film sensitivity
(ISO25-5000) if DX code film is loaded. If film
without DX code is loaded, set the sensitivity
manually. (see Fig. 15)
Raise the back cover release knob 傘 and turn
in the direction of the arrow to open back cover
惨.
★ After the cover is opened, return the back cover
release knob 傘 to its original position.
★ Make sure that you do not touch the inside of
the camera.
★ When loading film for the first time, remove the
"protective sheet" that is in the camera.
Place a new roll of film in the film chamber.
Draw out the tip of the film, holding the
magazine in place.
Draw the film tip as far the FILM TIP mark
inside the camera. Close the Back cover firmly.
Turning on the main switch causes a motor
sound to be heard and at the same time the film
to be wound automatically.
★ When the main switch is on, press the shutter
release button.
★ When using film that is not DX coded, turn on
the main switch then press the shutter release
button once.
If the film is wound correctly, a “1” will appear in
the display panel.
★ If the film is not wound correctly, a “0” will be
blinking in the display panel (Fig. 14). Open the
rear cover and reload the film.
To Next Page
Loading...
