Operation
5
5
5 Operation
5.1 Loading the Roll Film Cartridge
Before starting the following procedures, make sure that the Speed Con-
trol Knob is in the STOP position.
✎
If the Mars Controller is to be used, make the necessary Key en-
tries for the target frame on the Controller before inserting the
Cartridge.
1
Insert the ANSI Cartridge
into the Loading Port on the
left of the machine.
✎
Ensure the Cartridge is
loaded in the correct di-
rection.
2
When the Cartridge is properly inserted into position, the film leader is
automatically unwound and taken up by the Take-Up Reel.
✎
The Misfeed indicator on
the Control Unit lights up
red if the film leader is not
properly unwound.
If the Indicator is on, re-
move the Cartridge from
the Carrier and start the
procedure over.
To Next Page
Loading...