38
With the SR-T 201, connection for X sync.
only with cordless flash units is obtained by
simply sliding
the unit
all the way into the
X-only hot shoe. X-sync. connection may also
be made via the X terminal for units with cords.
FP-sync. connection, however, must be made
by plugging the flash's PC cord into the FP
terminal.
With the SR-T 202, either X or FP sync. is
available through the hot shoe or the single
threaded PC terminal. With cordless or corded
units properly connected with the camera,
simply turn the sync. selector switch so that its
index points to the appropriate indication.
The hot-shoe contacts are disconnected to
avoid shocks when a unit is not inserted.
To Next Page
Loading...
