18
appearance of a red bar from the right in the
SLS window over the word "FILM." If the
crank rotates during only a small part of the
stroke or not at all on the SR-T 200 and
201 or if the red bar does not appear on the
SR-T 202, repeat steps
1 through 6. With
the SR-T 202, the red signal will move
gradually toward the left as you take the
first 15 or so frames, indicating that film is
advancing properly.
CAUTION
Film should be handled and loading done in
subdued light-at least shaded from direct
sunlight by the body.
..
• . ' - ,: . •. , .. -~
FILM SPEED
Each film on the market has an ASA or DIN
exposure-index number to indicate its sensitivi-
ty to light. For correct match-needle exposure,
the meter of your SR-T must be set for the
effective exposure index of the film in use.
Setting film speed
To do this, lift up on the milled ring of the
shutter-speed dial and turn it until the proper
ASA indication appears centered in the film-
speed window ·and locks in that position when
To Next Page
Loading...
