Minolta SRT 101 - P. Disassembly of Inner barrel

P. Disassembly of Inner barrel
1. Dismount the front and rear lens components from the inner barrel(1110 set).
2.
Disconnect
the
pressure(1424)
engaged
with
the
operation
plate
pin(1407)
and
loosen
and
take out three setscrews(B61-1-7>2.2) located around the inner berrel so that the press
barrel holder(1115) may be taken out from the inner barrel(1110).. Then, take out the
diaphragm press barrel(1112), six diaphragm blades(1371 set)and the diaphragm operation
plate(1113).
3. Take out the washer(1379) with care so that the washer may be not deformed and then
pull out of the inner barrel the cam ring{1111).
4. Disconmect the engagement of the both ends of the aperture spring(1420) and then take
out the coupling washer(E-1.9) and the operation Jever(1874 set).
Caution: In some cases, an adjusting washer is located below the operation lever(1374 set)
so that care should be taken not to lose it.
11 | 3set
i) 1 iset