Minolta SRT 101 - A. Mounting of Top cover; B. Mounting of Bottom cover

A. Mounting of Top cover
Check point before mountings
* Check if the lead wires of the camera body are kept in order ;~
* Check if the eye-piece lens is free from dust or stain.
1,
Clean
the
counter
window
of
the
top
cover(1004)
and
install
the
top
cover
to
the
camera
body
by
means
of
three
setscrews(B2)-1.7
x2.7).
2.
Tighten
to
the
rewinding
shaft
bearing
the
rewinding
seat(3353)
and
to
the
rewinding
shaft
the
rewinding
knob(2355
set).
3.
Install
the
winding
lever(3155
set)
to
the
winding
lever
seat
and
locate
thereover
the
washer(W-28),
and
the
winding
lever
spring
(3158)
and
hold
them
in
position
by
means
of
the
winding
lever
cap(3171).
4,
Insert
into
the
speed
dial
ring(2155)
the
sensitive
plate
spring(2005),
on
which
are
located
the
sensitive
plate
sheet(2153)
and
the
speed
dial
scale
plate(2151).
Hold
the
sensitive
plate
sheet
(2153
set)
and
the
scale
plate(2151)
from
the
upper
side
there
of
and
insert
the
long
bended
or
folded
portion
of
the
sheet(2153)
into
the
elongated
slot
of
the
film
speed
ring
of
the
shutter
base
plate
A.
Then,
rotate
the
scale
plate(2151)
so
as
to
coincide
the
screw
holes
and
hold
it
in
position
by
means
of
one
setscrew(B31-1.7%2.5).
When
installed,
the
scale
plate(2151)is
pushed
toward
the
clockwise
direction
while
the
screw
is
threadably
engaged
and
tightened.
B. Mounting of Bottom cover
Check points before mounting;
* Check if the exposure controlling switch upon pushing down the pre-view button be-
comes “OFF" when the camera body bottom is exposed and the shutter is set, and also
if the switch becomes “ON” when the button is pushed down again.
* Check if the lead wires and located on the switch-overs witch terminals.
1. Embed the bottom cover(1005 set) in the bottom portion of the camera body and hold it
in position by means of two setscrews(B31-1.7%3).
Check polnts after mounting ;
* If upon the change-over switch of the bottom cover being turned “ON", the pointer within
the view-finder swings;
* If upon setting the change-over switch to B.C. the pointer stops at the battery check
mark,