Minolta SRT 101 - Page 31

10.
ll.
12.
13.
14,
15.
16.
17.
18.
19.
speed
of
1000,
then
loosen
two
setscrews(B11-1.4
Fig.
36
2.5)
so
that
the
speed
index(5057)
may
be
positioned
at
the
screws(B11-1.4<2.5)
so
that
the
speed
index
(5057)
may
de
positioned
at
the
lowest
position
of
the
speed
figure
plate
letter
1000
by
adjusting
the
second
curtain
spring
tube
(2063).
When
adjustment
is
made,
reciprocate
a
few
times
the
speed
index(5057)
so
as
to
settle
the
string,
and
then
check
the
position,
Clean the viewfinder glass of the eye-piece frame(5016 set) and attach the same by two
frame setscrews(5061 set) and attach the same by two frame setscrews(9158). Then
adjust the parallax.(See P, 27).
Withdraw the switch holder(4251) from the base plate by loosening and taking out one
sétscrew (B11-1.7%5.3)and one setscrew (B]3-1.4% 2).
Attach AY coupling string (4080).(Gee P. 40).
Adjust the needle following cam position. (See P. 41).
Insert the return spring(4057) with its bended Fig, 37
portion being placed upwardly into the needle
following axis(4052) of the needle following base
plate and insert the rotate axis(4054). Attach
the return spring(4057) to the rotate axis(4054
setjas illustrated in the Figure and then insert
the following upper lever (4056). Then tighten the
following lever nut(9451) and attach coupling
washer(E-1.2) into the notch portion of the
following axis (4052).
Adjust the opening angle of the needle following
upper lever and lower lever (See P. 41).
Take out the connecting ring F4 set jig and the
jig for adjusting the following pointer cam position.
Attach temporarily the switch holder (4251 set) by
two setscrews (B11-L,7 X 3.3, B13-1.4.x 2) and make
the adjustment of the AV safety switch contactor.
(See P. 42).
Check the brightness. (See P. 55).
Loosen and take out one setscrew(B31-1.7%2.5) of the speed dial, and then take out the
speed dial scale plate(2151), the sensitive plate sheet (2153 set), the sensitive plate spring
(2005)and the speed dial ring(2155). Then, attach the top cover. (See P. 25)