Minolta SRT 101 - Page 33

Check
points
after
mounting;
ae
* Check if the self-gear actuates correctly.
= Check if the coupling string (4080) extending
backwardly of the base plate(1002 set) Fig. 43
actuates lightly and smpothly when the
coupling string (4080) is lightly pulled back
50 a5 not to bedisengaged from the pulley =a
and when the connecting ring is actuated
by means of the connecting ring pin, If
the movement of the coupling string (4080)
is heavy, the cause is that the washer
(1064) is deformed or the front cover (1006)
is attached to the wrang position. Check
and make suitable countermeasures against
such defects.
Check if the mirror lifts up when the
mirror lock is lowered and if the mirror
comes down when the mirror lock is
returned to its initial position, When and
if there is something wrong with the
mirror lock, adjustment for the mirror lock
must be made accordirg to the following
instuction:
Mirror
lock
adjustment:
Push the operation lever-A(5153) of the
mirror box in the direction indicated by
the arrow and engage with the hook lever
plate(5169). Then release the hook lever
plate so as to hold the mirror in a clear
position, (Gee Fig, 43). In this position,
check if the clearance between the mirror
lock release lever (5153) and the tip end of
the mirror lock lever-A(5118) is in the
order of 0.5 to 1.3mm when looking down
the mirror box from above. When the mirror lock is out of order, the cause is that
the clearance is less than 0.5mm or the mirror returning lever faver fails to click in
because the mirror lock release lever(5135) touches the mirror box. Disengage the
engagement of the returning lever(3154) and the release lever-B(5117) of the mirro.
box so as to let the mirror come down, Displace slightly the mirror lock knob(S152)
from its click in position and make an adjustment for the clearance by bending the bended
portion of the release lever (5195) is spaced apart by the maximum distance from the
attaching bossfor the front frame of the mirror box.