Minolta X-300 - Page 15

Wi Sprocket gear positioning procedure
Fig. | BFig. 2
Winding base plate A
Winding sdler gear if
ome) ; ff
Sorocket idier Re
Sorocaet gear
2
5 .
. With the winding idler gear crest fitted in hole a' of winding base plate A and with the
sprocket idler gear bottom fitted in hole §), set the sprocket gear so that the shaft under
the sprocket gear is parallel with winding base plate A. :
. Then. put a mark on the tooth of the winding idler at hole a), as shown in Fig. 2.
@ After marking the winding idler gear. align the mark with hole (a) and set the sprocket
gear as shown in Fig. 1.