Minolta X-300 - Page 17

Mi Winding gear positioning procedure
MIFig. 1 Winding idler gear position BFig. 2
Mark
1. Make sure that the winding idler gear is positioned as shown in Fig. 1.
2. Allow 3036 to move in the direction of the arrow, then set the winding gear so that the punch
mark of the winding gear is aligned with the mark of the winding idler gear. (Fig. 2)
Mi Reversion stop lever stop timing adjustment
1. Position the winding operation plate as shown in Fig. 3, and temporarily set the winding opera-
tion lever.
. With the winding claw and reversion stop lever fitted into the winding gear as shown in Fig.
3, press the winding operation plate in the direction of arrow ©) while applying a load to the
sprocket in the direction of arrow @ so that the winding claw is set securely onto the wind-
ing gear.
Fig. 3
Winding operation lever
3.
Applying
a
load
to
the
sprocket
and
winding
operation
plate
as
shown
by
@
and
(B®).
turn
the
reversion
stop
lever shaft
until
the
winding
operation
lever
is
disengaged
from
the
winding
operation
plate. (Fig. 4)
MFig. 4
Reversion stop lever shaft