Minolta XE - Page 145

1. How to Confirm Manual Time
M@iMeasuring Instruments
:081 Standard Circuit Tester (Model SC-]I)
: Digital Time Counter (Model TC-1)
: Shutter Tester
W@Standard Value
Set Position of “SS SEL” of| _Indication of Shutter Tester —_| eR Time
081 Standard Circuit Tester | Standard Figure Allowed Figure
1/1 | 1000ms 758 ~ 1320ms (+0.4Ev) 1 sec.
1/4 ___-250ms 189~330ms (+0. 4Ev) 251ms
1/1000 0.98ms 0.563~1.71ms (+0. 8Ev) 2 ms
Hi How to Confirm
1. Unsolder the lead wires of SW4(+side) and Mg (+and—sides) of circuit base plate
plate B (0602) and set them to the tester as shown in the follwing diagram.
@ Digital Time Counter e Shutter Tester
SEP-COM SW: SP Curtain Running Direction: DOWN
FUNCTION : EXP-T
Trigger Level A-CH: +1 (V)
B-CH: +1 [(V)
Trigger Slope A-CH!+
#081 Standard Circuit Tester
SS SEL: 1, 1/4, 1/1000
BCH: + V SEL:3.0V
ay
Body Earth
Digital Time Counter
SW4(+)
081 Standard Circuit Tester
Shutter Tester
2 .Select a shutter speed by the “SS SEL” dial of the 081 standard circuit tester.
Press the “RESET” SW of the 081 standard circuit tester, release the shutter, and
Confirm that the measured figure of 1/1, 1/4 and 1/1000 remains within the range of
the rated figures.
3 .If the measured figures of 1/1, 1/4 and 1/1000 don’t remain within the range of the
rated figures, check the shutter block.