Minolta XE - Page 77

+ Using the special tool {Tool No. 081-2721-75), turn the
gear round in the direction of the arrow mark, and set
it at the position shown in the diagram.
Fig-4
2703
«Turn the gear round in the direction of the arrow mark,
and set it as the position shown in the diagram.
«If the spring is strong the body time lag won't be
secured.
«If the spring is weak, the mirror won't move up.
Fig-9
The upper side of the shutter
+ 2734
2731
* Turn 2734 round in the direction of the arrow mark, and
i set it at the position shown in the diagram.
«If the spring is strong, it won't be pushed enough by the
hold lever spring (081-2738) and won't be pressed to the
Mg.
Fig- 10 «lf the spring is weak, it may not be uniformly separated
the Mg. causing speed variations.
Iron piece lever
eS 081-0620
Mech, time operation lever
081-0619
0. Imm