Minolta XG-7 - Page 43

SELFTIMER
The electronic selftimer built into
your
XG-7 can be
used
to
delay release of
the
shutter
for
about
1O seconds after actuation.
To operate it:
1. Advance
the film.
2. With
the shutter-speed/function
selector at a
setting other than
"B,"
move
the
main
switch to
align
the
index
with
SELF
TIMER.
3.
Depress
the operating
button. The blinking
light
on the
front of
the
camera will indicate
the
delay
has been started.
Approximately
2.5 secs.
before
the exposure
is made, the
indicator
will blink
faster to signal
the end
of the delay.
You
may cancel
the selftimer
by moving the
main
switch to
"OFF".
NOTE
o
After
using
the selftimer be
sure
to move
the main
switch off of the
"SELF-TlMER"
setti
ng.
o
ln
automatic mode,
the
self timer will
cancel
if exposure
conditions exceed
the
upper range
of
the metering system.
Opera-
tion will
resume when
aperture or other
conditions
are adjusted
so that exposure
conditions
are within
metering
range.
www.orphancameras.com