1918
LOADING THE FILM
4. Close the back cover.
• The film automatically advances to the first frame
and
“
1
”
appears in the data-panel frame counter.
• If the film has been loaded improperly, “0” will
blink on the frame counter and the shutter will
not release. Open the back cover and repeat the
loading procedure.
• Once the film is loaded, the battery-chamber lock
will engage preventing the back cover from being
accidentally opened until the film is rewound.
2. Place the film cartridge into the film
chamber.
GETTING STARTED
3. Extend the film leader to the film-tip
mark. The film must lay flat.
• If the film tip extends beyond the index mark,
push the excess film back into the cartridge.
To Next Page
Loading...
