Need help?Do you have a question about the Mintion Beagle and is the answer not in the manual?
General| Night Version | Yes |
|---|---|
| Camera Resolution | Up to 1080P |
| Auto Time-lapse Video | Yes |
| Frame Rate | Up to 25fps |
| Upload Printable File | Yes, Only gcode files |
| Video Compress | H.264/H.265 |
| Compatibility of 3D Printers | Marlin firmware |
| Videos/Printable Files Storage | Micro SD Card |
| Connect to Printer | USB Cable |
| Temperature Monitor | Yes, for Hot End & Hot Bed |
| WiFi Connectivity | Supports 2.4 GHz 802.11g/n |
| Power Source | Plug-in |
Weight and Dimensions| Weight | 150g |
|---|
Details on connecting the power and USB cables for camera and printer setup.
Instructions for connecting the camera to a 3D printer via USB for control.
Steps to connect the camera to a WiFi network using the app's AP configuration.
Steps to power up the camera and prepare for WiFi configuration.
Steps to log in, connect the camera to the printer, and control via app.
Details critical operational warnings, user responsibilities, and manual disclaimers.
To Next Page