Mira Vier User Manual

8
9
The following functions can be altered individually to adjust how the shower
operates:
F1 - Maximum Showering Water Temperature. This is the temperature the shower
cannot go beyond when in use.
F2 - Eco. The shower will stop automatically
after 5 minutes. When this setting is “on”,
maximum available showering flow is
limitedtohalftheownormallyproduced.
“ECO” symbol is displayed. When setting
is “off”,maximumshoweringowwillbeat
fullowunlessFlow Range (F6) is limiting
the water ow. “ECO” symbol goes out
whenmorethanhalfowisselected.
F3 - Warm-Up. When this setting is “on”
and the shower is started, there is a short
delay(5seconds)beforewaterowsand
temperaturedisplaywillashtoindicate
shower is waiting for selected display
temperature to be achieved. When shower
stops, temperature has been reached
and shower is ready for use, press “ ” as
normal. If temperature cannot be found,
shower will stop automatically after 5
minutes.
When “Warm-Up” setting is “off”,temperaturedisplaywillnotashandshower
operates as normal.
Note! When used with some combination boilers, the warm-up function may be
impaired. This is due to the functional
nature of combination boilers.
F4 - Clock Setting. To set the time.
F5 - Clock Display. When Clock Display
is “on”, time is displayed when shower has
stopped, or after 10 seconds of inactivity
whilst the shower is running. When Clock
Display is “off”, the time is replaced by the
showering temperature.
on off
FUNCTIONS

Mira Vier Specifications

General

Brand	Mira
Model	Vier
Category	Network Router
Language	English