Mira Vision Dual User Manual

9
F7 - Control Frequency. An unreliable
functioning of the appliance (not always
able to change settings of shower) may
indicate radio interference by another
device transmitting locally on same
channel. Changing channel may resolve
this problem.
F8 - Count Down Display Enable. If
enabled, the remaining shower time is
shown instead of the clock. During the
countdown the flow indicator display
segments will fade but re-illuminate as
each minute elapses, the Wireless User
Interface will emit a single beep when 2
minutes are left on the countdown and 2
beepsasthenalminutepasses.Forthe
nal10secondsofshoweringthedisplay
is fully illuminated.
F9 - Shower Run time. If previous
function (F8 - Count Down Enable) has
been activated the operating duration of
the shower can be adjusted in 1 minute
increments of between 1 - 30 minutes.
F10 - Bath Fill Mode. Enables or disables
bath fill mode, when bath fill mode is
enabled the following features are
available:
Bath Fill Duration and Temperature
Allowsthebathllruntimeandtemperature
to be adusted.
• Bath Fill Duration - 1 - 20 minutes
• Bath Fill Temperature - 30° - 48°C
Bath Fill Learn Mode. Allows the Wireless
User Interface to memorise both the
temperature of water and the time duration
required for the digital mixer valve to
supply water to the bath.

Mira Vision Dual Specifications

General

Brand	Mira
Model	Vision Dual
Category	Controller
Language	English