Do you have a question about the Mirabelle MIRBDA6032 and is the answer not in the manual?
Read and follow all instructions pertaining to risk of fire, electric shock, or injury.
Adhere to all instructions to avoid voiding warranty or causing damage/injury.
Install by licensed tradesmen; use authorized accessories for residential use.
Includes warnings for children, suction fittings, electrical appliances, hyperthermia, and pregnancy.
Provides cut-out dimensions for the 6042 Galatia model.
Provides cut-out dimensions for the 7242 Galatia model.
Cut-out template and dimensions for under-mount tubs, use for Winterhaven 7140.
Cut-out template and dimensions for drop-in tubs, use for Winterhaven 7140.
Details on bath preparation, pump access, and structural support.
Instructions for removing debris and cleaning the bath surface.
Step-by-step guide for positioning, leveling, and securing the whirlpool.
Guidance on using mortar for support and ensuring the tub is level.
Cut-out template and dimensions for the St. Augustine 6060 model.
Cut-out templates and dimensions for Boca Raton 7242 and 6640 models.
Cut-out template and dimensions for the Edenton 6636 model.
Cut-out template and dimensions for the Edenton 6036 model.
Cut-out template and dimensions for the Edenton 6032 model.
Details on GFCI protection, dedicated 20 amp service, and wire gauge.
Diagrams for Total Massage, Air Massage, Whirlpool, and Bradenton/Provincetown circuits.
In-line heaters need a dedicated 20 Amp, 120 Volt GFCI protected circuit.
Table detailing length, width, depth, and height for various Mirabelle bathtub models.
Instructions for sanding and buffing to remove minor scratches and burns.
Contact service line for cracks and major surface damage.
Steps to diagnose and fix a whirlpool motor that fails to start.
Steps to diagnose and fix motor overheating or cycling issues.
Steps to diagnose and fix a motor making humming noise but not starting.
Steps to diagnose and fix issues causing low water flow in the whirlpool.
Steps to identify and resolve water leaks in the bathtub system.
Guide on adjusting jet direction, water flow, and air induction for optimal performance.
Explanation of the three buttons for whirlpool pump, power level, and wave action control.
Explanation of the three buttons for air blower, power level, and wave action control.
Overview of combined whirlpool and air bath controls and their operational modes.
Guidance on lifting, leveling, and supporting the tub during installation.
Information on available deck space for faucet mounting on the bathtub.
Table detailing deck dimensions for various drop-in Mirabelle bathtub models.
Table detailing deck dimensions for skirted Mirabelle bathtub models.
Requirement for a separate GFCI protected circuit for electrical shock prevention.
Need for an access opening for servicing the pump/motor.
Guidance on using templates for oval tub cut-outs and careful placement.
Procedure for static and operational testing to check for leaks after installation.
Explanation of the air bath's automatic cleaning and purge cycle for air channels.
Steps for flushing the pump and pipe system and cleaning the tub surface with detergents.