Need help?Do you have a question about the Mirage Omnisat and is the answer not in the manual?
General| Brand | Mirage |
|---|---|
| Model | Omnisat |
| Category | Speaker System |
| Language | English |
Arrange 5 OmniSat speakers and LF-150 subwoofer for Home Theater with Dolby Digital.
Connect speaker wire from amplifier/receiver to satellites, respecting polarity.
Connect subwoofer output from receiver/amplifier to subwoofer's Xover Bypass input.
Use 'Small' setting for bass management and set crossover to 70Hz as a starting point.
Balance speaker output levels using pink noise test pattern for consistent output.
Adjust subwoofer phase switch (0-180 degrees) for fullest, most accurate bass.
Arrange 5 OmniSat speakers and LF-150 subwoofer for Home Theater with Dolby Pro Logic.
Connect speaker wire from amplifier/receiver to satellites, respecting polarity.
Connect subwoofer output from receiver/amplifier to subwoofer's input.
Set subwoofer frequency control (e.g., 70Hz) to balance bass and mid-bass frequencies.
Balance speaker output levels using pink noise test pattern for consistent output.
Arrange 5 OmniSat speakers and LF-150 subwoofer for stereo home theater setup.
Connect left/right speaker wire from receiver to subwoofer and then to satellites.
Connect the remaining 3 OmniSat speakers to amplifier/receiver outputs.
Set subwoofer frequency control (e.g., 70Hz) to balance bass and mid-bass frequencies.
Balance speaker output levels using pink noise test pattern for consistent output.
Adjust subwoofer level control to achieve neutral balance between subwoofer and main speakers.
Adjust subwoofer phase switch (0-180 degrees) for fullest, most accurate bass.
Omnipolar technology uses natural room reflections to create a greater sense of realism.
Describes how to use the supplied mounting clip with an OMNISAT stand.
Instructions for mounting the OMNISAT speaker using a ceiling clip.
Simple wall mount using a screw and channel system for upright or inverted mounting.
Secure wall mount using the Macromount bracket with 3/8"-16 thread insert.
Guidelines for optimal placement of left and right channel speakers relative to the listener.
Guidance for positioning the center channel speaker for optimal dialogue clarity.
Recommendations for placing surround speakers for immersive sound effects.
Tips for placing OmniSat speakers on a bookshelf to optimize dispersion and minimize resonance.
Instructions for connecting speaker wire to OmniSat using binding posts, respecting polarity.
Detailed technical specifications for the OMNISAT speaker system.
Detailed technical specifications for the LF-150 subwoofer.
Details warranty periods and coverage for speaker and amplifier sections.
Lists conditions not covered by the Mirage warranty.
Provides contact information and procedures for obtaining warranty service.
To Next Page
