Mirarobot S60 FPV - User Manual

Questions and Answers

S
Stephanie RossAug 3, 2025
What to do if the LED flashes rapidly and Mirarobot Drones won't respond after binding?
- A
  Austin HawkinsAug 3, 2025
  If the LED on the receiver of your Mirarobot Drones flashes rapidly and the quadcopter doesn't respond after binding, it could be due to several reasons. First, ensure you wait at least 5 seconds after powering on the transmitter before connecting the flight battery to the quadcopter. Secondly, check and replace or recharge the flight and transmitter batteries if their charge is too low. Lastly, move the drone and transmitter away from large metal objects, wireless sources, or other transmitters, then try connecting again.
J
Jon MeyerAug 8, 2025
Why is the LED flashing rapidly and Mirarobot S60 FPV Drones won't respond during binding?
- J
  Joseph JenkinsAug 8, 2025
  If the LED on the receiver of your Mirarobot Drones flashes rapidly and the quadcopter won't respond to the transmitter during binding, there are a few potential causes. * First, the transmitter might be too close to the drone during binding; power off the transmitter, move it further away, disconnect and reconnect the flight battery to the drone, and then follow the binding instructions again. * Second, the bind switch or button may not have been held while the transmitter was powered on; power off the transmitter and repeat the binding process. * Third, interference from metal objects, wireless sources, or other transmitters could be the issue; move the drone and transmitter to a different location and try binding again.
H
Haley DuranAug 15, 2025
How to fix Mirarobot Drones that will not respond to throttle?
- M
  Matthew SmithAug 15, 2025
  If your Mirarobot Drones will not respond to the throttle, it may be because the throttle is too high or the throttle trim is too high. Reset the controls with the throttle stick and throttle trim at their lowest settings.
J
Jared EverettAug 21, 2025
What to do if Mirarobot S60 FPV crashes on lift-off?
- C
  Colleen BergerAug 21, 2025
  If your Mirarobot Drones crashes immediately upon lift-off or doesn't lift off, the propellers may be in the wrong locations. Make the necessary adjustments to ensure they are correctly placed.
C
christina81Aug 27, 2025
Why Mirarobot S60 FPV Drones smells burnt and does not function?
- K
  Kristin LesterAug 27, 2025
  If your Mirarobot Drones doesn't function and smells burnt after connecting the flight battery, it is likely that the flight battery was connected with the wrong polarity. Replace the 3-in-1 board and ensure you connect the flight battery with the correct polarity this time.