Setup for your MiraScreen
If MiraScreen connected to Home WiFi router, then please
connect your phone or laptop to the same Home WiFi
router. Launch web browser on your phone or laptop, then
access the IP address (Shown on main screen) of
MiraScreento enter setup page.
2. If MiraScreen does NOT connected to any Home WiFi
router, then please connect your phone or laptop to SSID
of MiraScreenvia WiFi.Launch web browser on your
phone or laptop, then access the IP address
(http://192.168.203.1) of MiraScreento enter setup page.
3. The setup page of MiraScreenwill be shown on your
phone or laptop.
Settings and Firmware Upgrade
1. Internet: Connect your MiraScreen to local Wi-Fi
network.
Note: The connection between MiraScreen and your
device may be disconnected when MiraScreen connects
to local WiFi network instead.
2. Password: Change the password of MiraScreen
3. Resolution: Output resolution of MiraScreen
4. EZAir mode: Mirror only (recommended).
Mirror+streaming for iOS 11.1 and 11.2.
5. Upgrade: upgrade the firmware of MiraScreen.
To Previous Page
Loading...