Mircom FA-1025U User Manual

LNOTICE
All information, documentation, and specifications contained in this manual are
subject to change without prior notice by the manufacturer.
®
FA-1025U
Fire Alarm Control Panel
INSTALLATION and OPERATION MANUAL
©1998 by Mircom Technologies Limited
Printed in CANADA, Dec 2005
LT-536 Rev. 4

Mircom FA-1025U Specifications

General

Alarm Type	Photoelectric
Alarm Sound Level	85 dB at 10 feet
Standards Compliance	UL 217
Battery Backup	9V battery
Humidity Range	10% to 95%
Interconnect Capability	Yes, up to 24 devices
Power Source	120VAC, 60Hz

Summary

Introduction to FA-1025U Fire Alarm Control Panel

Mechanical Installation of FA-1025U Panel

Function Selection for FA-1025U

Wiring Procedures for FA-1025U

Detection Zones Wiring

System has 5 detection zones. Refer to figures for wiring and wire size.

AC Power and Batteries

AC power connection, battery types, standby/alarm duration, electrical rating, battery charger.

Trouble Indicators and Control

Common Trouble LED

Yellow LED flashes for any panel trouble.

Trouble Silence Switch

Silences common trouble buzzer. Buzzer sounds continuously if no trouble and switch is in silence.

Sequence of Operation

Normal Operation

All indicators are normally OFF except for the green A.C. On LED.

Alarm State

A red zone alarm LED illuminates steadily for incoming alarm.

Signal Silence Procedure

Describes silencing signals after alarm initiation and subsequent alarms.

System Checkout Before Power On

Power Up and Troubleshooting Guide

Appendix A: Compatible Smoke Detector Devices

Product Warranty Information

Appendix B: Battery Calculations