Need help?Do you have a question about the Mircom TX3-P300-HA and is the answer not in the manual?
General| Model | TX3-P300-HA |
|---|---|
| Operating Voltage | 5-16 VDC |
| Frequency | 125 kHz |
| Buzzer | Yes |
| Housing Material | Polycarbonate |
| Type | Card Reader |
| Technology | Proximity |
| Card Technology | 125 kHz |
| Operating Current | 100 mA |
| Output Format | Wiegand |
| Read Range | Up to 7 cm |
| Operating Temperature | -30°C to 65°C |
| Operating Humidity | 0% to 95% (non-condensing) |
| Dimensions | 12.1 cm x 8.0 cm x 1.9 cm |
| Weight | 4.2 oz (119 g) |
Specifies mounting requirements according to 2010 ADA Standards.
Explains proper grounding for safety and electrical shock prevention.
Step-by-step guide for installing the Universal enclosure, including flush and surface mount.
Instructions for mounting the Universal Slim-Line enclosure.
Details the flush mounting process for Continental enclosures.
Explains how to network TX3 panels via RS-485 and Ethernet.
Details typical wiring arrangements for Lobby Control Units.
General layout and detailed description of controller board connectors, switches, and jumpers.
Details the bottom connectors of the controller board for microphones, inputs, outputs, and power.
Details the top connectors for telephone lines, door strikes, and relays.
How to set the unit's RS-485 ID address using DIP switches (SW1).
Guide to configuring the system using a PC and Mircom TX3 Configuration Software.
Steps for updating the panel firmware using the Configurator software.
Initial steps and verification for starting system configuration.
Details on the physical installation of NSL Relay cabinets and their sizes.
Instructions for wiring the TX3-NSL-8M Main Controller Board, including connectors and lines.
Steps to update the firmware for the NSL Main Controller using the configurator.
How to add controllers to RS-485 or Ethernet networks, including ID setup.
To Next Page
