Need help?Do you have a question about the Mirpol LUXE and is the answer not in the manual?
Catalog of all components included in the garden pergola kit.
Secure the vertical columns to the base plates.
Attach the middle beam connector to the central beam.
Insert hinge rings into the gearbox drive shaft on the beam.
Place columns and beams, ensuring correct orientation of drain ports.
Secure front and rear beams to the column corner connectors.
Connect left and right beams to the columns.
Attach the other front and rear beams to the structure.
Install the top column cover plates onto the corner connectors.
Adjust column positions and mark ground for anchoring points.
Drill Ø10x80mm holes at marked positions for secure installation.
Use expansion pipes and screws to fix the pergola to the ground.
Apply glass glue evenly on column drains and beam joints.
Position the middle beam D onto the front and rear beams C.
Insert the slats E into the brackets on the beams.
Fasten flaps using screws K2 and gaskets K3.
Insert plastic jams N into the ends of each flap.
Attach the hand crank J to operate the flaps. Installation complete.
Guide to aligning flap supports for proper pergola closure.
Verifying concentricity of flap holes after adjustment.
Instructions for optionally installing corner supports using self-drilling screws.
General| Brand | Mirpol |
|---|---|
| Model | LUXE |
| Category | Outdoor Furnishing |
| Language | English |
To Next Page