Mission 529M User Manual

MISSION
ENGINE ING
USB-PD converter
Quick Start Guide V1.0
STOP! Please read this before
connecting your Mission 529M
Note: If the power source does not support
a selected voltage, the 529M will remain at
the nearest supported voltage below that
selected. For example, if 15V is selected and
15V is not supported by the source, then the
output of the 529M will remain at 12V or 9V.
Remember to check
the specifi cations of
your power source to determine the available
voltages.
WARNING! Do not increase the
voltage above that recommended for
the devices(s) you are connecting.
Exceeding the recommended voltage
may damage your device. Do not
forget you have set it to a higher
voltage and then connect it to a lower
voltage device as damage may occur.
If you regularly change voltages, it
is recommended to always visually
check the position of the switch
before connecting a device.
Input
USB PD 3.0 Type C
Output
6V, 9V, 12V, 15V, 18V @ 3000mA Max
2.1mm center pin negative
Dimensions
2.4” x 1” x 1” 1.1oz
Construction
Aluminum case Blue anodized
www.missionengineering.com
info@missionengineering.com +1-866-333-1828
Note: If the power source does not support
a selected voltage, the 529M will remain at
the nearest supported voltage below that
selected. For example, if 15V is selected and
15V is not supported by the source, then the
output of the 529M will remain at 12V or 9V.
Remember to check
the specifi cations of
your power source to determine the available
voltages.
WARNING! Do not increase the
voltage above that recommended for
the devices(s) you are connecting.
Exceeding the recommended voltage
may damage your device. Do not
forget you have set it to a higher
voltage and then connect it to a lower
voltage device as damage may occur.
If you regularly change voltages, it
is recommended to always visually
check the position of the switch
before connecting a device.
Input
USB PD 3.0 Type C
Output
6V, 9V, 12V, 15V, 18V @ 3000mA Max
2.1mm center pin negative
Dimensions
2.4” x 1” x 1” 1.1oz
Construction
Aluminum case Blue anodized
MISSION
ENGINE ING
USB-PD converter
Quick Start Guide V1.0
STOP! Please read this before
connecting your Mission 529M
www.missionengineering.com
info@missionengineering.com +1-866-333-1828

Mission 529M Specifications

General

Device Type	Media Converter
Model	529M
Power Supply	5V DC
Data Transfer Rate	10/100/1000 Mbps
Ports	1 x RJ45
Fiber Type	Multimode
Wavelength	850 nm

Summary

Mission 529M Quick Start

Important Notes and Warnings

Key notes on voltage behavior, critical warnings against exceeding voltage limits, and advice on checking switch positions.

Input and Output Specifications

Details on the USB PD 3.0 Type C input and the 6-18V DC output with 2.1mm center pin negative.

Physical Characteristics

Information on the device dimensions (2.4"x1"x1"), weight (1.1oz), and construction (Aluminum case, Blue anodized).

Product Features and Operation

Features Overview

Describes the 529M's capability to convert USB-PD power to selectable DC voltages for audio equipment.

Detailed Input/Output

Explains USB-PD requirements, max output power, and connection types for the 529M, including cable ratings.

Voltage Selection Guide

Instructions on how to select output voltages (6V to 18V) using a screwdriver, with factory default at 9V.

Connector Polarity Warning

A critical warning to verify connector size and polarity of connected devices before use.