Mission VM-PRO - Internal Switch Settings; SW1: Active;Passive Pickup Select; SW2: Sparkle Switch; SW3: Impedance Switch

top of the circuit board, and looks similar to the picture in
Figure 2.
Figure 2.
To adjust the trim-pot insert a small electronics or jewellers
flat head screwdriver into the adjustment screw. Turning the
screw counter-clockwise will allow some signal to pass at
heel down. This allows the VM-PRO™ to be used as a variable
boost control to blend between a lower volume for rhythm
and a higher volume for lead Turning the screw clockwise
will send more of the signal to ground eventually reaching the
default point at which the signal is completely muted. The
trim-pot is 25 turns end to end, so you may find you need to
turn the screw two or three whole rotations before there is a
noticeable difference. Once you have reached the approximate
volume you need, you can make smaller adjustments to
precisely tune the position to your preference.
WARNING! Do not attempt to remove the baseplate or
change the internal battery while the pedal is connected to
an external power supply and/or amplifier. Make sure that
ALL external connections are removed before opening the
pedal. To reduce the risk of damage, avoid touching any
other components in the pedal. Do not attempt to use any
power supply with specifications other than those listed this
manual. Check all cables and power supplies for signs of
damage before use. Do not connect damaged power supplies
or cables. Replace cables or power supplies showing any signs
of damage.
Mission Enginring Inc.
www.missionengineering.com info@missionengineering.com
©Mission Engineering Inc. 2019. All rights reserved. VM-PRO™ is a Trademark of Mission Engineering
Inc. Trademarks, registered trademarks, product names, logos and other materials are the property of their
respective owners.
Saty
Inruions

Read, Keep & Follow these instructions

Heed all warnings

Clean only with dry cloth

Do not use this apparatus near water

Do not expose the apparatus to dripping or
splashing and ensure that no objects filled with
liquids, shall be placed on the apparatus

WARNING: To reduce the risk of fire or electric
shock do not expose this apparatus to rain or
moisture

Unplug this apparatus during lightning storms or
when unused for long periods of time

Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions

Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat

Only use attachments/accessories specified by
the manufacturer

Prolonged listening at high volume levels may
cause irreparable hearing loss and/or damage.
Always be sure to practice “safe listening.”

Refer all servicing to qualified service personnel.
Service is required when the apparatus has been
damaged in any way, such as:
- power-supply cord or plug is damaged
- liquid has been spilled or objects have fallen
into the apparatus
- the unit has been exposed to rain or moisture.
- the unit is dropped or the enclosure is
damaged
- the unit does not operate normally or changes
in performance in a significant way
Buffered
Volume Pedal
VM-PrO
Adnd
ConfigurAtion
Guide
MISSION
ENGINEING