Go to
MistKing
.com for more information on systems and parts
Mistking
®
is a Registered Trade Mark of © All Rights Reserved
Controller is ON and connected MistKing® system is misting
Controller is OFF and idle
Current time clock
Low relative humidity alarm
System is in day mode
System is in night mode
LCD Display
Hygrostat - Thermometer Timer Connection
1.
Connect the BLUE lead on the hygrostat controller to the
power adapter of your MistKing misting system.
2.
Connect the BLACK lead to your pump and ZipDrip (if
available). DO NOT plug ZipDrip to blue lead.
REMEMBER
REMEMBER to keep the humidity sensor away from direct
mist or it will become waterlogged and read humidity at
99.9% for several days until it dries. If this happens, use a
hair dryer to dry the sensor. Be careful not to burn it.
NOTE: Hygrostat controller works only with
MistKing systems and therefore requires
additional Mistking components to work
properly.
Using the hygrostat with non-MistKing
equipment voids warranty.
MistKing® Hygrostat Controller (HT-24), with humidity probe, is able to precisely monitor the humidity and maintain specified levels
based on programmed requirements. Different settings can be set for day and night.
Model: HT-24
Hygrostat Controller
To Next Page
Need help?
General