13 GB
extract the remaining air from the board
1
until it is completely flat.
Then turn the valve head anti-clockwise so it
comes out upward (Fig. C1).
Now place the board
1
flat on the ground
(Fig. N1).
Then fold the board
1
once and place the
nose over the tail (Fig. N2).
Then fold the tail and nose again, making sure
the external fins under the board
1
do not
buckle (Fig. N3).
Do not fold the board
1
along the
outside edges of the fin box. This will
cause excessive tension in the board
1
.
Now fold the opposite side to about the middle
(Fig. N4).
Then fold the board
1
once more onto the
opposite side so the external fins are on top
(Fig. N5).
Use the strap to lash up the board
1
.
Attach the fin protector
15
to the fins so they
remain straight whilst packed.
Using the product
Adjusting the paddle length
Stand straight and raise one arm up; bend
your palm to about a right angle (Fig. J).
Open the locking lever
4a
on your paddle and
slide the extension up until the paddle handle
fits below your bent palm. Close the lock on
the locking lever
4a
. Your paddle is now set to
the correct length.
Important: Do not extend the paddle
shaft
3
past the ”STOP” mark. The
paddle will otherwise become unsta-
ble and could break.
Using on the water
Note: Be careful not to hurt others when carrying
the board
1
in windy conditions. Always keep the
fins toward you.
Note: You can use the board
1
standing up or
sitting.
Standing up:
In this position, use the leash
9
as an addi-
tional safety measure.
Do not attach the leash
9
to your ankle when
using the board
1
on flowing water, e.g. water
with rapids such as streams and rivers.
Always attach the leash
9
to your ankle in
offshore winds.
If you find yourself in distress, always stay on
the board
1
. Never abandon the board
1
in strong offshore winds, or you may drown. In
this case, use the international distress signal to
draw attention to yourself: stand or sit on the
board
1
and slowly and clearly raise and
lower your straight arms at your side (Fig. P).
Attach the leash
9
as shown in figure G:
1. Attach the leash
9
to the rear D-ring
1c
.
2. Pull the loop on the leash
9b
through the
D-ring
1c
.
3. Pull the leash strap
9a
through the loop on
the leash
9b
.
4. When standing to use the board
1
in
deeper waters, attach the leash
9
to the
leg / ankle (Fig. H / I).
Seated:
To use the board
1
in a seated position, you will
need to install the foot rest
18
and the seat
16
(Fig. O). Proceed as follows:
Installing the foot rest
18
:
Insert the tube end of the foot rest
18
through
the first loop
19
from the side.
Insert the opposite end through the second
loop
19
until both are in the middle of the
board
1
.
Installing the seat
16
:
Place the seat
16
on the board
1
so your
legs are slightly bent when your heels are
touching the foot rest
18
.
To Next Page
Loading...