Mistral MF850UBY21 - Assembly; Fitting the Feet

5
Wall xing
bracket
Sturdy feet 2pcs M4X30 4pcs
Your Flame Effect
Electric Fireplace
Congratulations on the purchase of your
new Heater. Before using your new heater,
it is important that you read and follow the
instructions in this Use and Care booklet, even
if you feel that you are quite familiar with this
appliance. Find a place to keep this booklet
handy for future reference. Attention is drawn to
section dealing with ‘IMPORTANT SAFEGUARDS.’
This appliance has been designed to operate
from a standard domestic power outlet. It is not
intended for industrial or commercial use.
Assembly
Before using the heater, the feet (supplied
separately in the carton), must be tted to the
unit. Remove the heater and the feet from the
carton, feet mounting screws are contained in
the satchel with the Instruction Manual.
When using heater as a portable appliance than
the feet (Supplied separately in carton) must rst
be tted.
The feet are to be attached to the base of the
heater enclosure with the 4 screws (M4X30 4pcs)
provided and following the steps below:
• Place the heater on the oor with the bottom
facing up. Please take care of the power
switch while the heater is bottom up.
• There are four feet mounting holes at bottom
of the heater as indicated Fig1.
• The plastic feet have a location post, make
sure these posts are aligned and positioned
in the corresponding holes at the base of the
heater, then turn feet to align with the two
screw mounting holes as shown in Fig2.
• Attached the feet to the base of the heater
with 2 screws for each of the feet and tighten
with a screwdriver to secure as shown in Fig3.