Mistral MF850UBY21 - Operation; Heating Element and Air Intake; Thermal Safety Cut-out; Safety Tip Over Switch

9
Operation
When operated for the rst time, the unit may
emit an unpleasant burning type smell. This is
normal, and will disappear after a short period
of use.Always choose a safe location for the
heater, keeping in mind the safety precautions
outlined.
Ensure that all packaging has been removed
from the unit before use.
The appliance can be operated either by the
switches located on the top right hand side of
the heater or by supplied remote control.
• Place the heater on a level, hard and heat
resistant surface or x it to the wall, as
applicable.
• Plug the power cord into a suitable 230 -
240V~50Hz wall outlet.
• Set power on/off switch to position “I”.
• Press on the O/I button, or press the button
ON/OFF on the remote control,the ame
effect illumination will be activated.
• Select the desired function:
• Dimmer button: Press and repeatedly press
this button to control the ame effect
illumination intensity or turn illumination Off.
This dimming feature is not step-less, but can
make selection of 5 light intensity levels.
• Press the Heating select button, or press
corresponding heat selection button on
the remote contol: This ame effect heater
consists of fan forced heating with two
dedicated heating setting, 1000watts or 2000
watts. For low heat, push the 1000W heat
button once. For high heat, push the 2000W
heat button.
Warning: The heating element box and fan
air intake / outlet is positioned on top the
heater. This area gets hot during operation
and should not be operated under , near
or on top of ammable materials such as
curtains drapes , other non -heat resistant
materials like Carpet , Vinyl , oating or
Timber oors that could discolor or be
permanently damaged as a result of
accidental airow obstruction , position
heater on heat board between heater and
non-heat resistant substrate. Do not insert
or allow foreign objects to enter any grille
opening as this may cause an electric
shock , re or damage the heater, contact
with the elements inside the heater could
result in electric shock.
Thermal Safety Cut-out
This appliance is tted with a safety cut out,
which will operate if the heater overheats (eg,
due to blocked air outlet). For safety reasons,
the heater will NOT automatically reset. To reset
the heater, disconnect the heater from the
power outlet. Let the heater cool down before
reconnecting the heater to the power outlet and
switching it back on.
WARNING: In order to avoid a hazard due
to inadvertently resetting the thermal cut-
out, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
Safety Tip Over Switch
The heater comes equipped with a safety tip
over switch. It will cut off the power due to
accidental knocking over.
Technical Specications
Power Supply: AC 220-240V ~ 50Hz
Power Consumption: 2000W
NOTE: As a result of continual
improvements, the design and
specications of the product within may
differ slightly to the unit illustrated on the
packaging.