MiTAC 770 User Manual

MITAC 770 ALL-IN-ONE PC CHASSIS
INTEGRATION WITH THE ASROCK H77TM
DESKTOP BOARD
To install the optional VESA mount supporting bracket, remove
the 3 screws that secure the stand to the chassis and shift
downwards to free the stand from the locating pin.
Fasten the additional cover plate to the rear of the chassis if the
VESA mount bracket is used.
Position the VESA mount bracket over the 4 beveled screw
mounts. Fasten all 8 screws on the bracket securely.
10. Installing the VESA Mount Bracket 11. Positioning the VESA Mount Bracket 12. Fastening the Additional Cover Plate
Before securing the HDD mounting bracket to the chassis,
connect the SATA cables.
An additional heatsink-positioning screw behind the heatsink
needs to be fastened to secure the heatsink.
The system fan may need to be removed to allow SATA cable
connection. Once the SATA cables have been connected, secure
the fan by fastening all relevant screws.
7. Connecting the SATA Cables to the HDD 8. Removing and Replacing the System Fan 9. Fastening the Heatsink-Positioning Screw
Unfasten the two screws on the underside of the chassis to
enable the removal of the rear cover.
When inserting the IO shield, check that it is orientated correctly.
1. Unfastening the Rear Cover Screws
Once the rear cover screws have been removed, slide the cover
upwards, then lift the cover away from the chassis.
2. Lifting the Rear Cover 3. Inserting the IO Shield
Connect the supplied converter board to a single USB header the
desktop board and connect the converter cables.
Secure the HDD to the mounting bracket prior to insertion by
fastening the 4 retention screws.
Fasten the ODD to the mounting bracket prior to insertion.
4. Connecting the Converter Board 5. Fitting the ODD Mounting Bracket 6. Fitting the HDD Mounting Bracket

MiTAC 770 Specifications

General

Brand	MiTAC
Model	770
Category	Desktop
Language	English

Summary

Chassis Access and Preparation

Rear Cover Screws and Removal

Unfasten screws and lift the rear cover to access the chassis interior.

IO Shield Installation

Insert the IO shield, ensuring it is correctly oriented.

Component Mounting and Connections

Converter Board and Bracket Installation

Connect the converter board and fit the ODD/HDD mounting brackets.

HDD, Fan, and Heatsink Securing

Connect SATA cables, manage system fan, and fasten heatsink screw.

VESA Mount and Final Assembly

VESA Mount Bracket Installation

Install and position the VESA mount bracket, securing it with screws.

Additional Cover Plate Fastening

Fasten the additional cover plate to the chassis rear when using the VESA mount.

LCD Integration Notes

LVDS Connector Insertion

Insert the LVDS connector with correct alignment, avoid pulling wires.

Jumper Settings Verification

Confirm jumper settings for Backlight Inverter and Front Panel voltage.

BIOS Configuration for LVDS

Configure BIOS by navigating to Advanced, North Bridge, and setting LVDS panel type.

General Integration Notes

Thermal Retention Mechanism

Thermal retention mechanism is not required due to chassis mounting points.

Thermal Pad Placement

Secure the thermal pad into its correct position on the chassis.

Desktop Board Installation

Install desktop board by aligning IO shield and swiveling into place.

SATA and Data Connections

SATA power cable provides power for HDD and ODD.

Single USB Connection

Connect single USB to dual header, aligning red cable to PIN 1.

Wireless Connection Setup

Connect both wireless antennae to the adapter for maximum bandwidth.

ASROCK H77TM Desktop Board Overview

Board Connector Identification

Overview of the ASRock H77TM desktop board connectors and components.