MiTAC Pluto E220 - Page 17

Change History
Revision
Description
Date
By
R0.01
Initial E220 BIOS Setup menu.
08/26/2013
Lilia.Zhang
R0.02
1. Main menu add MAC address string support & Modify
Processor Information
2. Remove some menu in Advanced like “Platform Trust
Technology” “Trusted Computing”.
3. Add S5 RTC Wake Settings Menu
4. Add Device page for RF Onboard Lan items
5. Modify Chipset page’s menu
6. Modify Boot page to add “Fixed Boot Order Priorities”
items
7. Add “Alternate Boot Sequence item”.
8. Modify CSM Configuration, CSM support default as
Disable.
10/14/2013
Gibson.Lu
R0.03
9. Advanced menu add SMART Settings and Network
Stack Configuration items
10. Correct Security Configuration related items default
setting value.
11. Change item “AC Power Loss State” to Device Page
12. Modify Device Page H/W Monitor items string and
add VR temperature item
13. Remove Device page North Bridge & South Bridge
menu and move related items into Device page
14. Remove DVMT Pre-Allocated sub item “32MB” and
add USB Port 3~5 item in Chipset page
15. Modify Security Page related items help string
16. Add item “Reset System with ME disable Mode” and
remove item “UEFI Hard Disk Drive BBS Priorities” in
Save & Exit page
11/05/2013
Gibson.Lu
R0.04
17. Add Realtek PCIe GBE Family Controller item
18. Modify W83627DHG Super IO Configuration.
19. Remove Intel Smart Connect Technology item
20. Modify CPU Enhanced C state default as Enabled
and Max CPU C-state as C6 only
21. Modify SATA configuration to list mSATA HDD and
SATA HDD Port
09/11/2014
Gibson.Lu