21
•Use only capsules that are specific for this model
• Place a cup under the dispenser
• Slowly lift the control lever (1) backwards (until it stops)
(Fig. 9) and introduce a capsule in the slot provided (Fig. 10)
Preparation of coffee/tea/drinks
USEFUL TIP:
Use thick cups when preparing Espresso and heat them
beforehand. This will keep your coffee warm for longer. Cups
can be heated under hot running water.
Close the lever (1) completely and press one of the dispensing
buttons: short (A), long (B) according to your taste (Fig. 11)
NOTE
The machine is equipped with a pre-brewing system: when
a dispensing button (A) or (B) is pressed it starts dispensing,
stops and restarts automatically
• Repeat the steps above for additional cups of coffee/tea
using a new capsule for each drink
•To extract the capsule, slowly lift the lever (1). If the capsule
is not ejected, repeat the operation or press the dispensing
button (A) and lift the lever (1) at the same time.
ATTENTION:
Before inserting the capsule, slowly and
completely lift the control lever (1) located on
the top of the machine. For correct hygiene and
to maintain high product quality it is indispensable
to eject the capsule immediately after dispensing.
Fig. 8
1
1
B
B
A
A
Fig. 11
Fig. 9
Fig. 10
Programming dispensing
To regulate the doses, proceed as follows: with the machine
switched off, hold down the short coffee button (A) and switch
on the machine at the same time with the switch 9) (Fig. 8);
in this way you enter programming mode, indicated by rapid
blinking of both coffee buttons (A) and (B).
Press the coffee button if you want to reprogramme short (A)
or long (B) and stop, pressing the chosen coffee button again,
short (A) or long (B), when you have obtained the desired
amount of coffee. Switch off the machine with the switch (9)
to memorise the new dosage.
To Next Page
Loading...
