The RST (Reset) button clears the last results and sets
the DigiFlex in ready state (DigiFlex display will show
“Ready”). The DigiFlex will not respond to any other
button presses until it is in ready state. After every
measurement, steady the club shaft so there is no
movement. Press the RST button to prepare for next
measurement. See image 3-1.
The DigiFlex will provide an average of over 5 samples
based on the initial sample. Change the sample
mode by pressing the BLUE button. In sample mode,
the DigiFlex will display a total of 5 samples based on
the initial sample. The first measurement will be “Initial
Measurement”. All subsequent measurements will be
displayed as “AVG#:xxx(xx) CPM. Once the 5th average
has been measured and displayed, the DigiFlex will
start the averaging process over again from “Initial
Measurement”. Averaged results can be displayed in
integer or decimal mode. See image 3-2.
NOTE: The AVG mode setting is not retained in memory.
Change the sample mode by pressing the BLACK
button. While in Integer mode, the DigiFlex will round up
or down to the nearest whole number. For example, if
the resulting measurement is 285.35 CPM, the displayed
result will be 285. If the measurement was 285.53 CPM,
the result will be displayed as 286. While in Decimal
mode, all measured results will be two decimal places.
The display mode setting will be retained in memory
and set after the next power up. See image 3-3.
image 3-1
image 3-2
image 3-3
To Next Page
Loading...