Each of the lower row buttons are also used to access
the menu functions. The menu functions are used to
adjust the display settings and enable/disable Bluetooth
(if equipped). Any settings configured will be stored in
memory and applied whenever powered on.
To access the menu, press and hold the RST/Menu
button for 2+ seconds. The menu will appear on the
display as follows. See image 4-1.
Press the AVG/Select button to choose the item to
change. Each press will cycle the item chosen in the
menu. The chosen item will have the asterisk (*) next to
it. Once the item is selected, press the Mode/Set button
to adjust the setting. See image 4-2.
For example, to adjust the contrast of the display,
perform the following:
Press and hold the RST/Menu button for 2 seconds.
Press the AVG/Select button repeatedly until the
asterisks (*) shows next to “Contrast”.
Press the Mode/Set button until the display is set to your
preferred level.
Press the RST/Menu button normally (short press) to store
settings and return the DigiFlex to ready state.
See image’s 4-3 through 4-4.
The settings available for each item in the menu are as
follows:
Bluetooth (ON/OFF)
Brightness (1-8)
Contrast (25-50)
image 4-1
image 4-2
image 4-3
image 4-4
To Next Page
Loading...