INSTALLING MIVOICE MX-ONE HARDWARE, OVERVIEW
17 6/1531-ASP11301 Uen T2 2015-04-23
12 CONCLUDING ROUTINES
Before leaving the installation site, complete the following steps:
1. Clean up the site and remove objects like wrapping paper and cable pieces.
2. Dispose of waste material according to local regulations.
3. Print one copy of the safety document, and place it visible on site, see the
description for SAFETY.
4. Place the battery service instruction sheet (included in NTM 144 265 see
Mounting set for Battery) visible on site.
5. Make sure that the warning label (SVB 131 75) is fastened visible and close to
the AC/DC unit.
6. Make sure that all cables to and from the chassis have earth connections
mounted and that no cable shields are damaged.
7. Make sure that no internal cables are going outside the containment.
To Previous Page
Loading...
Need help?
General
