Mitel StreamLine 8-Port Switch - Note the Following

STREAMLINE 8-PORT DAISY CHAINING
Note: For daisy chaining the units, connect Uplink Port 1 of the first unit to Uplink Port 2 of the
second unit and so on and so forth. Refer to graphic below.
Existing CAT-3 Wiring Plant
MDF
Standard
CAT-5
cables from
StreamLine
Dongles to
IP phones
Standard
RJ11
cables
(CAT-3)
from wall
plate
Connect Uplink to IP PBX,
Router or a data switch Daisy
Chain Uplink ports together.
Standard
RJ11
cables
connect
LPC to
MDF
Single pair to
each wall jack
center pins
Existing CAT-3 Wiring Plant
MDF
Standard
CAT-5
cables from
StreamLine
Dongles to
IP phones
Standard
RJ11
cables
(CAT-3)
from wall
plate
Connect Uplink to IP PBX,
Router or a data switch Daisy
Chain Uplink ports together.
Standard
RJ11
cables
connect
LPC to
MDF
Single pair to
each wall jack
center pins
NOTE THE FOLLOWING
All of the above instructions provide basic installation information, necessary for the proper and safe functioning of
this equipment. Persons installing or maintaining this product must read all of the safety instructions and the parts of
system grounding which are applicable to the system being maintained. Only trained, qualified service personnel
shall install or maintain this product.
WARNING: FAILURE TO FOLLOW ALL INSTRUCTIONS MAY RESULT IN IMPROPER EQUIPMENT
OPERATION AND/OR RISK OF ELECTRICAL SHOCK.
WARNING: ANY CONNECTION TO AN OUTSIDE PLANT LEAD, AN OFF-PREMISE APPLICATION,
OR ANY OTHER EXPOSED PLANT APPLICATION MAY RESULT IN A FIRE OR SHOCK HAZARD,
AND/OR DEFECTIVE OPERATION, AND/OR EQUIPMENT DAMAGE.
 Keep these instructions with the equipment.
 Do not attempt to install or service this equipment unless you are skilled in the installation and maintenance of
electronic telecommunications equipment and have successfully completed specific training for this equipment.
- 4 -