MITEX SITE - Low Battery Alert

II
~ -..., ~~,.,."t~n,-,:>;"t~llf!'l ,\J- ,. '\"~ :':i.l" •• ~ ••
Fu nctiop ,: ~ . np 1: bp . ~ , ~~t~on .:
• • r ~
Battery Saver
The transceiver
will switch to battery save mode wh en it hasn't
received any
signal or hasn't been operat ed for more than 10 seconds.
When
th e transceiver receives an incoming s ig nal or is used to transmit,
th e battery saver mode wi ll switch off automaticall y.
Low Battery Alert
If
t he battery is l ow . the red LED will come on and an alert tone will
sound. If this happens, t he rad io will not transmit. You must then
recharge the batter pack or insert a fresh
ba ttery.
Monitor
You can use the Mo nit or key to listen to weak signals that you cannot
hear during
no rmal operation and to adjust the volume when no
signals are present on your selected channe l.
CTCSS and DCS
CTCSS
and DCS are used for privacy and to avoid recei vi ng unwanted
radio transmissions from other radio operators. Radios that do not
transmit t
he corre ct CTCSS or DCS will not be heard. This means
that you
will be ab le to communicate wi th the pe ople you want to
without having to
listen to other people who may also be sharing the
same
channe l.
These codes are pre-set and programmed by Mitex (www.mitexuk.co.uk)
10