IN THE EVENT OF AN EMERGENCY
• In the event of a re of the device, do not attempt to extinguish it with water. Use a re extinguisher
suitable for electrical res.
• If the device emits smoke, sparks, or a strong burning smell, disconnect it from the mains immediately
and contact your dealer or the listed customer service.
• In such cases, do not attempt to repair or disassemble the device yourself. This could lead to further
damage or injury.
• If the device causes an electric shock, disconnect it from the mains immediately. Do not directly touch a
person connected to the electrical source. Use a non-conductive object to separate the person from the
electrical source and seek medical help immediately.
NOTICE
• There are no known side eects for the applications listed here, provided that all safety instructions in
this user manual are followed.
• For all other uses not listed in this user manual, you may use this device only after consulting a physician.
• This device is not intended for industrial or clinical use.
• Consult your physician for health problems of any kind!
How do I know if the light is working properly?
- When the device is turned on, one of three modes (RED + NIR / RED / NIR)
will light up, based on which either the red LED chips in combination with
the near-infrared LED chips or only the near-infrared LED chips or only
the red LED chips will turn on.
- The near-infrared (NIR) spectrum is invisible to the human eye.
How do I know if the light is not working properly?
- No LEDs light up when any lighting mode is switched on.
- Only a portion of the LEDs will light up when any lighting mode is turned on.
- The LEDs ash instead of glowing when any lighting mode is switched on.
To Next Page
Loading...