1. Follow the safety instructions.
2. Fix the fully unpacked device in the stable position you will use.
3. Screw in the device into the E27 thread on the power cable.
4. Plug the power cable into an electrical outlet.
5. Switch on the device using the switch on the power cable.
6. Choose your preferred lighting mode.
A) Switch on the device for the rst time → RED + NIR mode lights up.
B) Switch the device o and on within 10 seconds → RED mode lights up.
C) Switch the device o and on within 10 seconds → NIR mode lights up.
- After the next switch within 10 seconds, it reverts back to RED + NIR.
7. Memory function: If you leave the device turned on in any mode for more
than 10 seconds and then turn it o, the next time you turn it on, the last
mode that was used for more than 10 seconds is automatically activated.
8. Expose yourself to light without clothes at a distance of 15 - 50 cm
from the light for 10 - 20 minutes per day.
- According to customer feedback, most users do not use protective
goggles and only keep their eyes closed during shining. However, always
wear protective goggles unless otherwise instructed by your physician.
- With a shorter distance from the light, a shorter illumination time is needed,
and vice versa.
- This one light application applies to one illuminated area. One area can be
illuminated 1 - 2 times per day. If the same area is illuminated, we recommend
a total time of no more than 30 minutes per day.
9. When you have nished using it, rst turn o the power switch and then
pull the mains plug out of the socket. This completely disconnects the device
from the power supply.
How to use
the device
To Next Page
Loading...
