SELFONE WIRELESS PRINT STATION™
INSTALLATION SETUP
QUICK START GUIDE
MODEL
D90-WIFI-1
Parts List
Contents Qty. Description
NUC
1 Ft. USB Cable
Power Adapter
Metal Plate
Black Screws
Silver Screws
Washer
Installation Set-up Guide
Manual
Wireless device
Connection to D90 printer
Connection to power
Attaches to the NUC
Screw hooks to for the NUC
Screws for metal plate
Washers for metal plate
QRef Manual
Intel Manual
1
1
1
1
2
2
2
1
4
1.
3.
Metal Plate
Silver
Screws
Washers
2.
4.
Power Adapter
Power
Button
USB connection
Type A
USB connection
Type B
Assembly
1. Attach metal plate to the back of the D90 printer using (2) silver
screws. (Note: Make sure to point arrow up on metal plate)
2. Attach black screw to the back of the NUC.
3. Insert NUC with attached screws to the metal plate on the back of the
D90 printer.
4. Connect USB Cable to the D90 printer and power adapter to the NUC.
5. Plug NUC to an outlet and press power button on the NUC.
*Make sure D90 Printer power is on before powering up the
NUC.
Back Screws
NUC
PRINT PHOTOS
FROM YOUR PHONE
1
2
3
Set your Wi-Fi connection to:
*If your browser opens automatically, tap “Start Application” and follow
instructions.
*If no browser opens, proceed to Step 2
Open Safari browser
and start application
iPhone
Android
Open Android browser
and start application
Follow on-screen instructions to select
photo from your phone, or take a new
picture to print.
*For other internet browsers, go to any webpage that starts with http://
(not https)
.SelFone_WiFi_Print
To Next Page
Need help?
General
