11 - 12
MELSEC-F
TROUBLESHOOTING11
11 - 12
(1) Initial error code (BFM#105)
(a) This address stores the error codes generated when the initial processing is
executed.
(b) Error codes are stored as binary values when the initial abnormal completion
signal (BFM#28...b5) is on.
(c) An error code is cleared when the initial normal completion signal
(BFM#27"0001
H", BFM#28...b0: ON) is turns on, but can also be cleared by
the following operations.
1) Writing the value in BFM#1600 to perform re-initialization or turning off
the PLC and Ethernet module
2) Re-downloading the parameter with FX Configurator-EN or sequence
program
(2) Open error code
(connection numbers: 1 to 8; BFM#124 to 194)
(a) These addresses store the result of the open processing for the applicable
connections.
(b) The results of the open processing are stored in binary values.
0 : Normal completion
Other than 0 : Abnormal completion (BFM#28...b6: ON)
(c) An error code is cleared by the following operations.
1) Reopening the connection that caused an open error
2) Performing the re-initial processing by writing the value to BFM#1600
(3) Fixed buffer sending error code
(connection numbers: 1 to 8; BFM#125 to 195)
(a) These addresses store error codes generated when an error in data sending
to an external device occurs during fixed buffer communication using the
applicable connection.
(b) A sending error code is cleared when the next data sending is normally
completed.
(4) Connection end code
(connection numbers: 1 to 8; BFM#126 to 196)
(a) These addresses store end codes returned from an external device as a
response during the fixed buffer communication using the applicable
connection.
(b) Determine how to handle the end codes in the responses by arranging with
the particular external device.
To Next Page
Loading...
