Mitsubishi Electric MN Converter User Manual

Contents Page
1 Foreword
1.1 Introduction of Maintenance Tools 1
1.2 Required Operating Environment 5
1.3 Installation 7
1.4 Starting and Ending the Application 14
2 Terms for Each Section
2.1 Design of Screen 27
2.2 Operating Method 27
3 On-Line Monitor Operation Method
3.1 On-Line Monitor Screen Transfer 28
3.2 Function Chart 29
3.3 Address Search Method 30
3.4 Main Screen 31
3.5 Function Selection Operations 32
3.6 Connecting Information 32
3.7 Operation Monitor 34
3.8 Malfunction Log 42
3.9 Optional Setting 44
3.10 Operation Control 47
3.11 Free contact of indoor unit 49
3.12 Remote error notification 51
3.13
Setting and Monitoring DIDO/AI/PI Controllers 77
4 Off-Line Monitor Operating Method
4.1 Off-Line Monitor Screen Transfer 113
4.2 Function Chart 114
4.3 Operation Monitor 115
4.4 System Information 119
4.5 Monitoring of Pre-error Data 120
4.6 Function common for each screen 121
4.7 Offline Analyze on Wide area access mode
125
5 File Names 126
6 How to change setting of Firewall
131
7 Troubleshooting 136
8 Trademark and license 143
Before using Maintenance Tools, read this manual thoroughly to ensure correct operation.
WT03939X20
Maintenance Tools
for MN converter & G-50A
- Advanced -
Operating Manual
Mitsubishi Electric Air-conditioner Network System

Mitsubishi Electric MN Converter Specifications

General

Brand	Mitsubishi Electric
Model	MN Converter
Category	Software
Language	English

Summary

1 Foreword

1.3 Installation

Details the two methods for setting up the Maintenance Tools.

1.3.1 Setting Up the Maintenance Tools (New setup)

Provides a step-by-step guide for installing the Maintenance Tools from scratch.

1.3.5 USB Serial driver installation

1.4 Starting and Ending the Application

3 On-Line Monitor Operating Method

3.3 Address Search Method

3.7 Operation Monitor

3.7.1 Screen Transfer Operation

3.8 Malfunction Log

Displays the most recent malfunction cases of the unit.

3.12 Remote error notification

Enables automatic notification of errors via telephone lines to registered destinations.

3.12.3 Selecting remote error notification mode

Specifies settings to enable the remote error notification function on the MN Converter.

3.12.4 Error notification testing

Tests the error notification function to ensure correct implementation.

3.13 Setting and Monitoring DIDO/AI/PI Controllers

3.13.1 Setting and Monitoring DIDO Controllers (66DC)

3.13.2 Setting and Monitoring AI Controllers (63MC)

3.13.3 Monitoring PI Controllers (60MC)

6 How to change setting of Firewall

3. How to change the setting of Firewall

Provides procedures for changing firewall settings based on Windows XP Service Pack.

3-1 [For Windows XP Service Pack 1]

Details firewall configuration for Windows XP Service Pack 1.

3-2 [In the case of Windows XP Service Pack 2]

7 Troubleshooting